Powerspec 3D Pro

 

PS_Ultra

PowerSpec_Ultra3DPrinter_Manual

PowerSpec_Ultra_Software.zip

 

 

 

ps3d pro

 

PowerSpec_Pro_3D_Printer_Manual

PowerSpec 3D Pro | microcenter.com

  • Price as Tested $999.99
  • Build Volume 226×144×149mm
  • Bed Style Heated
  • Temperature Control? Yes
  • Materials PLA, ABS, PVA
  • Print Untethered? SD Card
  • Onboard controls? Yes
  • Host Software ReplicatorG (MakerBot Desktop possible)
  • Slicer Skeinforge (MakerBot Slicer possible)
  • OS Mac, Windows, Linux
  • Open Software? Third-party software
  • Open Hardware? No

bla

PRO TIPS
Heat bed to 65°C for PLA. Print slowly. Use MakerBot Desktop instead of ReplicatorG. Check out Sailfish firmware.
WHY TO BUY
A dual extrusion machine based on a well-loved design that prints best in ABS.

Micro Center’s PowerSpec 3D Pro is essentially the MakerBot original Replicator (launched in early 2012, now retired), but it has a few design and materials improvements at half the price.

The black metal chassis of the printer is styled to mimic the Replicator 2X, but with hard composite boards with handle slots that cover the sides, with Replicator 2 style extruders. The directional buttons for onboard controls have been updated, providing tactile feedback when pressed. These details may seem minor, but they make the printer more enjoyable to use and easier to transport.

The included instructions step the user through setup of the outdated ReplicatorG, used with MakerBots until the release of MakerWare (with the painfully slow Skeinforge slicer). The 2X-style front lid doesn’t fully close, leaving a bottom gap and instead of a single-piece vacuum-formed top cover, it is replaced by a user-assembled acrylic-sheet hood that feels a bit fragile.

pspro dual

PowerSpecX_3D_Printer_Manual

PowerSpecX+Pro_Software

3D Printing News and Information